Tweet
Quick question about setting float heights on a c40tlrv... These are the PN: 6H4-14985-01-00 FLOAT floats that are not flat on the bottom. They are angled upwards towards the carb body over the half that is opposite the pivot. Crappy sketch attached.
The picture in the Yamaha service manual I have just shows a rectangular blob where the float is on the diagram describing measurement. Says to turn upside down and measure from carb body to top of end of float opposite the float valve.
Do I measure to the top of the whole thing (B in picture), or to the top of the angled "nose" (A in pic)?
The picture in the Yamaha service manual I have just shows a rectangular blob where the float is on the diagram describing measurement. Says to turn upside down and measure from carb body to top of end of float opposite the float valve.
Do I measure to the top of the whole thing (B in picture), or to the top of the angled "nose" (A in pic)?
Comment