Bent skeg

[JONSNELL]

Recently put a pretty nasty bend in the skeg of my F115. I have managed to get it within about 1/4" of being straight. What I did was use a claw hammer and block of wood, striking the one side and holding the block of wood on the other. So far I have spent about 3/4 hour to get to where im at so it s a slow process.

Just wondering if anyone has any other ways of doing this or suggestions.

Thanks in advance

Snelly

[Sequoiha]

You are doing the only thing you can do with out breaking it,, slow is better,

[rodbolt17]

typically the skeg only bends once.
usually it breaks the second time.