If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
If you are talking wiring inside control box then it only has red,blue and green wire going to trim switch and 2 brown wires going to neutral switch. Here is standard rigging wiring. 6YRW0035F2Wiring.JPG
Thanks-
I have a good 703 diagram that shows "Main switch", "buzzer", "neutral", "choke" etc. I guess you might say I'm looking for the internal schematic as to how each wire is routed. Looking for something like the attached file.
I'm looking for similar help. I have a 2001 T9.9 tiller model that I have to convert to remote. I have the elec. harness (6G8-82590-00-00), but I'm not sure where to connect to. If I unplug some existing connections to plug in the harness wires, what happens to the old wires?
Can't seem to figure it out.
Thanks, Marc
Comment