If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Thank you for your help and diagram, that helps a lot.
Will a broken band (part number 1) give me incorrect trim readings or just the trim sender? My problem is the trim gauge reads only one bar until it gets up past the half up position on the motor. Then the trim bars light up very quickly as you continue to raise the trim of the motor.
Thanks again for your help. Much appreciated!!!
Comment