If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I am in the process of replacing a head gasket and wanted to install the head with the proper tbolt ightening sequence. Does anyone have any suggestions or a recommended pattern?
Thanks,
John
The head bolts are numbered and torque specs are on head, just start at bolt number 1 and follow sequence.
Torque to half of spec torque to all bolts then start sequence over with final torque.
The head bolts are numbered and torque specs are on head, just start at bolt number 1 and follow sequence.
Torque to half of spec torque to all bolts then start sequence over with final torque.
Tweet
Comment