harness ends are cut off - slice help

[texaswildman]

Ok, harness it not going to work. I have no plug on the engine side as it is a used engine and someone apparently has cut the plug off.

I want to hook up this trim gauge and need to know if I am hooking up the right wires.



There is a pink, black, orange and gray that is taped together at the engine. I have traced the orange, black and pink to the trim sender at the mount in tnt.

My trim gauge has a yellow/red(ignition power), pink/red, orange/red, black from gauge to plug for harness. (I know the black and blue are for light)

Question: is it simple enough to just hook the black to ground, pink to pink/red, orange to orange/red for meter and splice yellow/red into my yellow switch control (that is fused)?

What is the grey wire? I shows in the rigging guide to go to the harness plug, but like I said, there is no plug end (cut off).

Adjust meter as the Clymer manual states and then I am good to go?

[boats.net]

Yes that should work, the grey wire you wont need it's for overheat light on digital gauge.

[texaswildman]

Cool! Thanks again. Between this site, the Clymer and my 2000 rigging guide I should be good to go on this yami. New animal as I have been a Johnson/Evinrude man for years.

If I can help anyone with 2000 60hp issues please ask.