If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I recently discovered that my 2006 50hp tiller can start while still in gear. Hopefully it's only a loose connection or a failed switch. Any ideas where to begin?
It's probably just out of adjustment. Its a mechanical cable / plunger block out system. Here's a link with a pic of the system and the adjustment : Boat Stuff :: Yamaha 50 Start Protection System picture by Hamfisted - Photobucket . Hope it comes out clear enough to read. Send me and email address and I can send you the factory service manual for the motor.
Comment