Last fall I purchased a new non-current 2000 Yamaha F80.
I bought the multifunc kit at the same time from the marina.
It was the 6YR-W0035-E1 kit containing:
6Y58350T82BK Multi-Function Tachometer.
68F825539000 Trim/Oil Harness
6Y583553N000 Gauge Harness.(2-Fuse)
This spring I installed and wired the outboard with a Yamaha flush control and key switch.
I used the rigging guide and shop manual for the install.
All seems to work except the trim gauge only indicates in a range from 4-5. In any normal operating position it all bars are present (5).
I have tried both states of the pink wire, disconnected and connected. No change in behavior.
The dip switches are set to OFF-OFF-ON.
The gray wire to the trim plug in the outboard has a bullet connector on it, but is not attached to anything. Does this need to be connected?
Does anyone have any other thoughts?
thanks,
charlie
I bought the multifunc kit at the same time from the marina.
It was the 6YR-W0035-E1 kit containing:
6Y58350T82BK Multi-Function Tachometer.
68F825539000 Trim/Oil Harness
6Y583553N000 Gauge Harness.(2-Fuse)
This spring I installed and wired the outboard with a Yamaha flush control and key switch.
I used the rigging guide and shop manual for the install.
All seems to work except the trim gauge only indicates in a range from 4-5. In any normal operating position it all bars are present (5).
I have tried both states of the pink wire, disconnected and connected. No change in behavior.
The dip switches are set to OFF-OFF-ON.
The gray wire to the trim plug in the outboard has a bullet connector on it, but is not attached to anything. Does this need to be connected?
Does anyone have any other thoughts?
thanks,
charlie
Comment