Rigging a 25 2stk. I have a few questions.

I have a 25HP 2 stroke built in mid 2006 that I'm trying to get rigged. I picked up a older 703 control box in nice shape that I'm trying to use, The only problem is that it has a ten pin cable and my 25 has a 7 pin connector so I'm going to need a new cable, I'd appreciate it if somebody could give me the correct part number for the seven pin cable.
my 703 box does'nt have the push in choke on the key but doe's have a momentary toggle switch under the key which I assume is the choke, If possible I'd also like to get the part number for the rubber cover that goe's over the choke switch.
The control box also has a harness with six wires coming from it that I assume( There I go assuming again) are for a speedo and Tach, Since this is going on a 15 ft. aluminum skiff that get beach launched I wont be needing them, Would it do any harm to disconect them inside the box when I replace the control cable??.
I appreciate any help I can get on this,
Thanks
bajafishnut

[boats.net]

All you need is the adapter, 703-8258A-00-00 7 pin to 10 pin adapter. Some of the older 703 control box were pull to open throttle and your motor needs push to open, check to see if it pushes or pulls cable when throttle up.

Thanks for the response.
I'll get the adapter ordered, I'll check out the control & motor I thought all 2 strokes were pull on so it sounds like I goofed on that.
Thanks Bajafishnut