Tweet
I am replacing my impeller, and thought it would be a good time to hit the oil seal at the top of the lower unit. I have 2 questions:
Do you really need the special tool "YB6096" called out in my Seloc manual? How much is this "tool?"
and
How in the world do I get to it? I removed the Protector Plate, and found a gasket that is not called out in any diagram that I can see. After that I am down to what I assume is the housing. This is round with a ~2" tab pointing toward the rear of the unit. The Seloc says 2 screwdrivers to "lift" out the housing, but there is no way without really maring the thing up. I have gone well beyond lifting, and am not moving anything with prying.
Does anyone have experience with this?
Do you really need the special tool "YB6096" called out in my Seloc manual? How much is this "tool?"
and
How in the world do I get to it? I removed the Protector Plate, and found a gasket that is not called out in any diagram that I can see. After that I am down to what I assume is the housing. This is round with a ~2" tab pointing toward the rear of the unit. The Seloc says 2 screwdrivers to "lift" out the housing, but there is no way without really maring the thing up. I have gone well beyond lifting, and am not moving anything with prying.
Does anyone have experience with this?