Fuel management

i have a fuel management system i would like to add to my boat but there are no ends and my motors were hooked to analog gauges c, can someone give me a diagram or tell me how to hook this up thanks in advance.

[jb123]

You need the gauge, harnesses and sensor.
Gauge can be tied in with the power of other gauges,and lights, harness connects to the gauge and sensor/s and sensor needs to be tied into fuel line.

i have all the sensors and wiring from what i can tell the green and green/white wire are for the tachs ,red power,black ground.and a yellow ?there are also 2 wires at the rear by the sensors a black and a red/white those i dont know.i have the gauge powered up and working but when i run the motors they do not show any fuel flow just 0.0 any help would be nice

[jb123]

the open wires at rear are for a water-sensing seperator.
yellow SHOULD be for constant power,( its been years since ive done mine).
is your sensor inline w/ the fuel line??
if so, unhok the lines and you should get a signal by blowing thru it.

[Irish Jig]

Try this site.

http://www.shipyardisland.com/images...ll%20Guide.pdf