Rigging 03 F115

[Camper_NE]

Hello, I will be rigging the F115 on a pontoon, The boat has a generic teleflex binnacle and cables.
I will be needing the harness(s)
There is a 10 pin round and a 4 pin square with only 2 wires on the engine. What is the two wires for? Tach? Will I be able to use the teleflex control?

Thanks

[boats.net]

The Teleflex controls will work make sure it is set up for push to open throttle. I would suggest a new switch panel(704-82570-08-00) and 10 pin harness 6X3-8258A-00-00 16ft or 6X3-8258A-10-00 20FT OR 6K1-8258A-40-00 26ft. The four pin connector is for oil warning and temp warning lights in tach and trim gauge signal. If you are using trim or tach with warning lights order 6Y5-83653-00-00 16ft Trim/Oil harness and 6Y5-83553-N0-00 gauge harness.

[Camper_NE]

Thanks for the info. I friend has a main engine harness from a 1998 yamaha v-6 200 10 pin. Will this work for my 2003 F115, I will still need to order the other parts from you. Switch / trim harness / gauge harness. I have the motor, will be picking up the pontoon this week, and then work (fun) begins.

Thanks for any info.

[boats.net]

The 1998 main harness(10 pin harness) will work, Yamaha has not changed that harness.

[Camper_NE]

Thanks for all the help, 1 other quick question?
There is a small hose routed to the rubber bushing where all the wires / cables come in too the motor, What is the small hose for? Vent, Fuel return to tank?

Thanks for you help