If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
unable to get the overheat horn to sound on an 01 250 OX66. I think on the HPDI's if you pull the kill switch, turn the key and release, you should here the horn. Didn't know if this was the same for the OX66
the thermosensors on each cylinder bank are connected by a pink and black wire, ground out the pink to the block or black and you should set off your buzzer.
Tweet
Comment