pstephens the link you posted on boats.net takes you to a 1986 engine parts list that the OP said was his motor
Announcement
Collapse
No announcement yet.
Shaking really bad once warmed up
Collapse
X
-
Originally posted by Miraclegrow View PostI drained the bowls one had a couple specs of dirt. The air box is missing 2 of the gaskets that seal up the carbs and there is quite a bit of fuel on the air box. Are those gaskets a must have?
Here is better parts blow out for your engine:
https://www.vansoutboardparts.com/ya...94,38237,66844
Jason
1998 S115TLRW + 1976 Aquasport 170
Comment
-
Originally posted by panasonic View PostI don't think an 86 engine would have RPM reduction...could be wrong though..Jason
1998 S115TLRW + 1976 Aquasport 170
Comment
-
Originally posted by Jason2tpa View PostLook at the part labeled #1, bottom of picture. This is the silencer. Is this part what you're referring to as the air box? If so, the gaskets that go in between each carb and the silencer are not the issue causing the shaking. But the missing gaskets are the reason you see fuel inside the silencer.
Here is better parts blow out for your engine:
https://www.vansoutboardparts.com/ya...94,38237,66844
Yes those are the missing gaskets I was referring too.
I'm gonna get it on the water this evening. And pull the temp sensor and pull the choke to see if that changes anything
Comment
-
Originally posted by Miraclegrow View PostGot it out on the water once the temp got up to 190 the motor started shaking again. Pulled the temp sensor off and it wouldn't shake again. Motor temp was up to 220. So that means I have a cooling problem correct? So replace the stat and water pump?Jason
1998 S115TLRW + 1976 Aquasport 170
Comment
-
Originally posted by pstephens46 View PostMaybe that '86 had a rpm reduction mode after all.
1986 was a good year for me. Met a group of girls from Holland that summer. They hung around for 3 months in NC.
The manual I looked in was for a 1984 50 ETN...but I think its the same manual for a 1986...could not find the exact models covered in the beginning pages...
Manual P/N LIT-18616-00-11
Where is Boscoe????
Comment
-
Originally posted by Miraclegrow View PostGot it out on the water once the temp got up to 190 the motor started shaking again. Pulled the temp sensor off and it wouldn't shake again. Motor temp was up to 220. So that means I have a cooling problem correct? So replace the stat and water pump?
Comment
Comment