Tweet
I have a 2016 8 hp and I'm adding a rectifier. The bolt it came with is all but useless. there is only one place to mount it with out a bracket and viable ground. I can't find any pic's or diagrams for placement.
Thanks
Thanks
-
-
Are you in the US? Is this an F8. F as in four stroke? -
yes I'm in US and it is a 4 stroke.Comment
-
When done I will upload pic's as I haven't found anything helpful on lineComment
-
The T8 is shown ash having an R/R mounted during production. I would mount an R/R on an F8 in the same location as is used for the T8. See diagrams below.
Comment
-
The way the harness is this looks like the only place. The two grounds will be on the bolt in picComment
-
That does not look like the correct place to me.
If you look at the diagrams it appears that the R/R bolts to the aft side of a piece that bolts aft of the CDI. With the attach bolt being positioned sideways with the threaded section forward.
What is the part number of the R/R you are trying to install?
Keep in mind I am working from diagrams. I sill don't even know the model of your motor.Comment
-
Was told it was a plug and playComment
-
one more picComment
-
the right oneComment
-
You are not trying to attach it to the correct mounting point.
Let the parts catalog be your guide. After all else fails, follow the directions.
Comment
-
-
rerouted the wires from the holder and here it isComment
-
Thanks Bosco!Comment
-
Yea. A success story. Good to hear.Comment
Comment