1993 yamaha 40 tilt ???

[megawatts]

have a 40 hp c40plrq. this is a tilt only. What needs to be done to make it into a trim/tilt ? swap motor? hydrolic cylinder? relay? I think that it can be converted over. it will hold a trim before take off and at full throttle but no trim up at full throttle. have to let off throttle trim then back on gas !! that sux any info thx

[boscoe99]

CMC PT-35 Tilt and Trim for up to 35 HP | CMC Marine

[megawatts]

cmc pt 35

has anyone ran one on their yammy 40 hp? the only difference I have seen is the thickness of the aluminum. the hydraulic units are inter changeable motor specs says 146 lbs? thanks and may be best deal on one?? thx

[99yam40]

always good to know they sell them on this site

PT-35 Tilt & Trim, Hydraulic