Hello, I am new here, lots of great info.
I have to remove and clean the carbs on my 1990 130v4 2 strokes motor, one needle valve is stuck (pouring gas) and it's time for a clean up.
I have the service manual, I already got the rebuild kits from our host.
Now , before I start, I am a bit apprehensive about removing the carb linkage and mess something up. The manual isn't giving much detail about how to unclip the linkage between the 2 carbs.
Is there any recommendation on how to go about this?
I'll take tons of pictures before hand and try to mark the position as much as I can but I was wondering if this was gonna be a nightmare to synchronize afterward.
I'll also keep a note of the idle air/mixture screw by screwing in until lightly seated and counting the turns for re-installed right?
Thank you.
Fmt
I have to remove and clean the carbs on my 1990 130v4 2 strokes motor, one needle valve is stuck (pouring gas) and it's time for a clean up.
I have the service manual, I already got the rebuild kits from our host.
Now , before I start, I am a bit apprehensive about removing the carb linkage and mess something up. The manual isn't giving much detail about how to unclip the linkage between the 2 carbs.
Is there any recommendation on how to go about this?
I'll take tons of pictures before hand and try to mark the position as much as I can but I was wondering if this was gonna be a nightmare to synchronize afterward.
I'll also keep a note of the idle air/mixture screw by screwing in until lightly seated and counting the turns for re-installed right?
Thank you.
Fmt
Comment