If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
the sole function of the diodes in the twin T&T setup is to allow individual switchs AND a single switch to operate multiple devices with the same set up.
they fail occasionally.
I don't know what specific diode(s) he is referring to either.
Lots of my answers are based on guess. Some wrong, some OK.
A guy on another forum was bitching about not being able to use email to ask questions of Yamaha. He was not receptive to my suggestion that he will get much better answers if he talks to someone in person, where they can make sure they really understand the question, rather than sending a cryptic email where the questions might be vague. He was not buying it.
I couldn't welded them back together. The wires are not tinned and they are rusted so the solder was giving me a hard time. I used a butt connector instead with adhesive lined heat shrink tubing. I hope it holds for the season while I get a replacement harness.
Definitely the wires are white inside of the harness.
Comment