If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Yes, I did one in sept. Port side manifold leaking into center cylinder, hydro locked threw a rod, and almost cut the block in half from the rod slinging around.
seen more than one fail.
also the F350 cyl head drain holes get blocked.
then the head freezes and cracks.
get 1-2 every spring.
enough that I am fairly quick at replacing the block/heads on an F350.
Comment