No power to ignition, tilt trim, 90 hp 2 stroke

[Yogibahr64]

Changed out the battery on my 1998 90hp Yamaha 2 stroke. Checked that all the wires were on and secure. Turned the key, nothing. Tilt trim is dead too.

[DennisG01]

Make sure positives are on positive and negatives are on negative. Then look again for a missed wire that fell behidn the battery somewhere. I assume you have fuses on the side of the powerhead? Do you have any breakers/fuses on the boat that are between the battery and the engine?

[Yogibahr64]

Thank you for your suggestions. I pulled both batteries out to check if I missed a wire. I visually checked the inline fuses on the engine but I can do a continuity check on them. I do have power to what I believe is the power pack.

[Jason2tpa]

You said you changed out the battery...does that mean you replaced a bad cranking battery with a new cranking battery? If so, was there a power issue before the bad battery went bad?

[Keithbaja]

All outboards if you have the main battery cabels connected (right) electrical will tilt/trim.