Hey folks, I’m new to this forum.
I've tried searching for my answer in this forum, but just need to be 100% sure.
I have 2 x 40xwt motors. I decided to put new battery cables on them and neglected to observe polarity when I removed the old ones. Kinda thought it would be simple to figure out.
My gut says positive to start relay and negative directly to starter motor itself, which is the ground for all the other circuits.
the Yamaha rigging manual says otherwise, or at least I think it does?
see attachment.
40 elec.png
ive circled what I think is wrong…it shows neg coming out of the left of the battery, going directly to the relay (top wire). Then it shows positive making a short hop down from battery to starter motor.
any help would be appreciated.
thanks!
I've tried searching for my answer in this forum, but just need to be 100% sure.
I have 2 x 40xwt motors. I decided to put new battery cables on them and neglected to observe polarity when I removed the old ones. Kinda thought it would be simple to figure out.
My gut says positive to start relay and negative directly to starter motor itself, which is the ground for all the other circuits.
the Yamaha rigging manual says otherwise, or at least I think it does?
see attachment.
40 elec.png
ive circled what I think is wrong…it shows neg coming out of the left of the battery, going directly to the relay (top wire). Then it shows positive making a short hop down from battery to starter motor.
any help would be appreciated.
thanks!
Comment