Yamaha 1995 F50 to 2005 F90 wirings help

[purplegodzilla]

I finally bought a Yamaha f90 for my Montauk after years of being underpowered.I have mounted the engine and steering.I am trying to use the old con*****er.However some of the wires are not hooking up. The only wire that I managed to fit was the round plug..There are 2 square plugs from the con*****er (which I presume are the tilt and trim)...I can't figure out which wires on the F90 to plug to..

I have looked at the parts diagram but not much help. I figured I would post here before I end up bringing it to a boat center to rig it up.

[boats.net]

The wiring should be the same on both engines. They both use the 10 pin main harness from key switch and if there is gauges they will use the square 4 prong trim/oil harness.