If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I had thought of that but I was trying to find "an easy way out". Your set up looks great. I'll look at my lift again to see if there is a practical solution.
I had thought of that but I was trying to find "an easy way out". Your set up looks great. I'll look at my lift again to see if there is a practical solution.
Thanks, John
Thanks. The galvanized extensions were about $250 each.
All the walk around PT planks, I stained and installed. Makes washing, changing oil change, etc, MUCH easier, especially in the shade!
Scott
1997 Angler 204, Center Console powered by a 2006 Yamaha F150TXR
Scott... Well, that is just TOO nice! It's almost like cheating!
No balancing on one leg with the other extended out behind you for a counter balance... no pushing yourself to reach just a "little bit" further... Very cool setup.
2000 Yamaha OX66 250HP SX250TXRY 61AX103847T
1982 Grady Weekender/Offshore (removed stern drive & modded to be an OB)
Comment