liquid gasket maker for joining block sections

[fisherman363]

What type of product is recommended for joining block halves on my 1998 two stroke outboard, I have Permatex Anaerobic gasket maker and Permatex Ultra Black gasket maker available would either of these be recommended?
Also should I use any coating on the other gaskets- head- waterjacket cover - exhaust covers- power head to lower unit? Thanks for any info.

[99yam40]

your Yamaha service manual for your motor should have all of that info.
since you fail to say what motor you have,
we have no idea what 98 2 stroke you are talking about

[fisherman363]

Service manual just says ( apply a light bead of liquid gasket maker compound ) motor is a 1998 25 hp two stroke 25ELRW.

[fisherman363]

gaskets are all from Yamaha- the head gasket appears to have a sticky coating but the rest do not?

[TownsendsFJR1300]

I use Yamabond #4 for the gasket-less block halves / cases.

NO sealer on the head gasket and un-less specified by your manual, sealer's not needed elsewhere.


.
.

[99yam40]

Yamabond Gasketmaker is what I used on my C40 and what my service manual called for on the crankcase.
a very small amount, anything that squeezes out on the inside is not very good for the internals when it comes loose and flys around in there