Tweet
I have a 2006 F90TLR. I had issues with my tilt motor last year so I pulled the motor and cleaned our all the carbon. It worked fine until now. I works up and down unless I tilt it all the way down. Then I get the relay clicking but not upward movement. If I tap the area by the tilt motor if will work again. I hate to replace the motor if it is not the issue as it works most of the time. Any suggestions
-
-
If tapping it makes it work, sounds like that IS the issue...
I'd pull it apart, inspect, replace brushes /worn parts, etc..
It'd be much cheaper that buying an OEM and better than a chinese knock off (IMO).
https://www.boats.net/catalog/yamaha...starting-motor
.Scott
1997 Angler 204, Center Console powered by a 2006 Yamaha F150TXR -
OP asked about a trim motor and you show a starter motor,Originally posted by TownsendsFJR1300 View Post
but I am sure her gets what you say about the brushes.
strange how that only happens in the complete down position thou ,
I would think it would happen in any position if the brushes were not making good contact some times.
I think checking all connections would be in order.
maybe a ground wire that gets a strain when fully down?
just something to look forLast edited by 99yam40; 06-21-2020, 07:19 AM.Comment
-
Originally posted by 99yam40 View Post
Well, I was close!
https://www.boats.net/catalog/yamaha...trim-tilt-assy
Capture.JPGLast edited by TownsendsFJR1300; 06-21-2020, 05:56 PM.Scott
1997 Angler 204, Center Console powered by a 2006 Yamaha F150TXRComment
-
Thank you for the suggestions. It is strange that it only stops working if you tilt all the way down. But a tap brings it back to life. I will go over all the connections again. If it persists I guess I will have to replace the brushes.Comment
-
How'd the brushes look last time it was apart?Scott
1997 Angler 204, Center Console powered by a 2006 Yamaha F150TXRComment
-
The brushes looked good still plenty of thickness and no signs of carbon or burningComment
Comment