If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Announcement
Collapse
No announcement yet.
Can leakdown or compression test show bad reed valve?
A bad reed valve may manifest itself in the form of lower than normal compression pressure but how would you know that it is the reed valve that is causing the problem when it might be something else?
I believe on a 2 stroke you could pull the reeds out completely and still get a good compression reading.
but I never tried that
You can even leave the throttle closed and get good compression reading,
I have verified that with testing.
So I would say no, you cannot tell if reeds are bad from those tests.
Visual inspection is the best way on the reeds
I know but this particular motor was over revved in neutral by accident. Was up against the rev limiter for 10 seconds. It was nasty.....rpms went up instantly. I'm thinking that could bend or break a reed.
Comment