Got a 1997 yamaha vmax 150 on a skeeter zx185. One of the power trim pistons was leaking where the piston comes out. Took a punch & hammer & gently tapped the trim cap in the direction to tighten it up & it was loose a little. Also noticed when running motor down the lake & letting off throttle the motor wanted to kick out of the water & drop back hard back down on the trim pistons. Question...? how do I make sure the large center "ram" piston has the proper amount of fluid as well as the 2 trim pistons?
Need help!!
Thanks
Need help!!
Thanks
Comment