Hi guys
Need your support
I'm changing the bearings of a F100 lower unit that had water intrusion/corrosion including the drive shaft needle bearing
https://www.boats.net/catalog/yamaha...casing-drive-1
part # 13
Put the bearing on place using a old drive shaft that use the same bearing size but then the drive shaft got stucked on the bearing and was very hard to turn over
Removed the bearing from casing and than is turning freely on the shaft.
When on place (on the casing) doesnt turn over and the shaft gets stuck
When out no problem
What I'm missing or doing wrong
I belive that is something most of you havent done but I would like "hear" your sugestions
Rod this ever happened to you?
Need your support
I'm changing the bearings of a F100 lower unit that had water intrusion/corrosion including the drive shaft needle bearing
https://www.boats.net/catalog/yamaha...casing-drive-1
part # 13
Put the bearing on place using a old drive shaft that use the same bearing size but then the drive shaft got stucked on the bearing and was very hard to turn over
Removed the bearing from casing and than is turning freely on the shaft.
When on place (on the casing) doesnt turn over and the shaft gets stuck
When out no problem
What I'm missing or doing wrong
I belive that is something most of you havent done but I would like "hear" your sugestions
Rod this ever happened to you?
Comment