Buy Yamaha Outboard Parts

Announcement

Collapse
No announcement yet.

704 control

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • 704 control

    Just installed a dual 704 control for my twin F150's.. after wiring up the individual up/down switches work fine but the twin switch on the lever handle is only driving 1 engine.. any idea how the wiring looks for this? also only see 2 blocking diodes on the harness, should there be 4?

    thanks,

  • #2
    Two diodes.

    Comment


    • #3
      many thanks.. I will check it out and see if I can find out why the dual switch is only moving 1 engine.

      Comment


      • #4
        Hi, quick question, the trim tilt relays shown in the diagram are in the motors right? the 704 control I installed has a harness with 2 multi min plugs on it and then 3 wire connectors from each trim tilt switch and 3 wires from the twin trim tilt switches that connect into the harness via the crimp connector plugs. I have used the 704-85721-00-00 WIRE SUB LEAD to connect into my wiring..
        Last edited by caysteve; 04-11-2014, 02:46 PM.

        Comment

        Working...
        X