Yamaha Saltwater Series II V76x wiring information for Yamaha LCD Marine

[RodPinar]

Hello, I need the information of a diagram pin out of a Yamaha Saltwater Series II V76-X with a Yamaha LCD Marine. Coming from the engine the are two connector and two Bullets cables. The first connector have the following color wires:
Grey, Pink, Orange and Black. The bullets wires are Green and Green\Red.
the other connector have the following color wires: Purple\White, Orange and Black.

My Yamaha LCD Marine have the following connectors color wires:
Connector 1:Green\Red, Green\White(two empty space)
Connector 2:Pink, Black, Orange

Bullet Connectors: Black, Blue (together) , Yellow (independent) and Green(independent)

Anyone with the data wiring of the cables and the correct wiring diagram for this particular case.
Thank you,
Rod.

[boscoe99]

Too bad the year and model of the motor and the gauge is not known. Here is a layout drawing that depicts an early circa 2000 year motor and gauge.

[rodbolt17]

I think the V76 was gone prior to 2000 however the wire colors remain the same.
DO NOT plug the black and blue together.

[RodPinar]

Year of the Engine

Thank you so much for your help, that diagram help me a lot. If will be possible find the wiring code information? I mean ...Blue -12V, Black -Ground, etc., etc.
Where I can find the information of the year of manufacturing engine?
Thank , you
Rod.

[boscoe99]

The year that the motor was made should be on a sticker on the side of a clamp bracket. If you have the complete model then you can get to the model year. The last letter in the model identity denotes the model year.

Green = tachometer
black = constant ground
red = battery power
yellow = key on power
blue = lights (normally)

Don't worry about the colours in the trim/oil harness. Sometimes they change across a connector. It is mostly fool proof. Just make the appropriate connections and it should all work.

[RodPinar]

Yamaha Saltwater Series II and LCD Marine Meter

Thank s for your quick reply!!! Appreciate a lot your expertise knowledge in this topic. Do you a pin out diagram or picture of the whole LCD Marine Meter where the pin information appear? The one post before help me anyway.
Thanks,
Rod

[boscoe99]

Why do you need information for the tachometer? Just plug it in per the drawing and it should work.

What are you trying to achieve?

I know that the black wire is for the ground. Orange is for a 5 volt reference to the trim sender. Pink is the sender return wire. The others are for oil tank status and if the gauge has it, an over temperature icon/lamp.