Yamaha F9.9CE Wire Loom

[wayfoot59]

Hi
I have just bought a used F9.9CE, 4 stroke,2002 model and i need to fit a short cable & socket to the existing bullet connectors on the motor. My aim is to connect into a Yamaha 703 control box, therefore i want to avoid any messing around with re-wiring etc.
I think these are available with existing female bullets so i can just plug in and go, so my question is...
Is there a specific socket for my outboard or will i be able to buy any general loom & Socket to fit to my 703 cable.
Many Thanks !

[boats.net]

703 control should come with main harness with a 7 pin or 10 pin connector to connect to engine harness.
2006 and Later 2-stroke Rigging Yamaha Outboard CONTROL STANDARD SIDE 703 PUSH Diagram and Parts

[wayfoot59]

So is there not a separate loom & socket from the motor ?
Therefore the 2 would connect together ?
Thanks

[boats.net]

If your engine harness doesn't have the 7pin or 10 pin connector then would have to replace engine harness to one from a remote model.
Don't have any information on a F9.9CE model but may can use same harness as the F9.9ELRA USA model. Number 9 in this link 2002 F9.9ELRA Yamaha Outboard ELECTRICAL 2 Diagram and Parts