Tweet
I just installed a used multifunction tach in my console and it seems to work fine for the 2001 z200tlrz. The tach is round and has both the mode and set buttons. There is a blinking symbol I don't understand and it has the look of a caption window and it's located right above where it reads "x100". I zeroed out the trip hours, thinking maybe that had something to do with it, but to no avail. Do any of you know what this could be and how I can eliminate it (or if it's a legitimate alarm that signals something I should deal with)? Thank you!
-
-
-
The symbol that's flashing is just to the right of the big "0" in this photo. Thank you.Comment
-
check the tach dip switch settings.
looks like its still set up for a 4 stroke.
correct settings are sw1 on,sw2off and sw 3off for your motor.
switchs are located behind a dime sized rubber plug.Comment
Comment