Fuel gauges on Simrad

[Pedro6767]

I have a 2008 33 Contender with 3 fuel tanks, 3 250hp with the command link square gauges, analog controls. There is a switch on my key panel that switches the gauge view from port to stbd tanks, becuase the fuel gauge can only show 2 tanks. I hooked up my Simrad NSS system to the command link via the gateway cable, but I can't get the 3 fuel tanks to display on the Simrads. Any ideas?

[boats.net]

Fuel Tank senders are not connected to Command Link Network, the fuel senders are connected direct to Command link gauge and Yamaha doesn't off Network compatable fuel senders.

[Pedro6767]

Ok but each fuel tank is sending a signal to somewhere. Is there a way to get all signals to the simrad network?

[boats.net]

You would have to find a NMEA 2000 fuel tank sender that would connect to Simrad network hub.

[boats.net]

Here is a link for sender, not sure if compatable with Simrad instruments, Maretron : Marine Electronic Instruments