If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have a 704 control box for a yamaha 250 2006. The tilt will work at motor but it will only go down at the control. Im not sure what all I need and how to take it apart to fix it.
Check wiring at control box and where wires go through dash(will need to remove the plastic cover on control box to gain access, would have to remove shift handle and disassemble to get trim switch out.
Tweet
Comment