Whats needed? - Yamaha Outboard Parts Forum

Buy Yamaha Outboard Parts

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

X

Blazer202

Junior Member

Join Date: Oct 2011

Posts: 7
- Share
- Tweet
#1

Whats needed?

10-15-2011, 09:29 AM

Hpdi motor,round command link tach and fuel round gauges, 2-6y8-82521-51-00 leads and 1- 6y8-82553-21-00. This is what I have. What else do I need to install this system?
Tags: None
boats.net

Super Moderator

Join Date: Dec 2009

Posts: 10360
- Share
- Tweet
#2

10-17-2011, 09:21 AM

What is model number of outboard, did you buy gauge kits(what part number) or just individual parts?

Regards
Boats.net
Yamaha Outboard Parts
Comment
Blazer202

Junior Member

Join Date: Oct 2011

Posts: 7
- Share
- Tweet
#3

10-17-2011, 10:29 AM

VZ300, Bought the gauges individually.....
Comment
boats.net

Super Moderator

Join Date: Dec 2009

Posts: 10360
- Share
- Tweet
#4

10-17-2011, 04:58 PM

If your VZ300 is model number VZ300TLRD or older then it is not Command Link Compatable, If model is VZ300TLR Command Link gauges will work on it.
You would need,
6Y8-81920-01-00 Multihub
6Y8-83553-01-00 Power harness
6Y8-8356N-01-00 Fuel sender/GPS lead
6Y8-81920-11-00 Inline Hub
6Y8-82521-21-00 3ft Pigtail Harness(will need two of these)

Regards
Boats.net
Yamaha Outboard Parts
Comment
Blazer202

Junior Member

Join Date: Oct 2011

Posts: 7
- Share
- Tweet
#5

10-17-2011, 05:21 PM

just ordered the parts from you! Thanks!
Comment

Previous template Next

Working...

X