Tweet
I would like to know how to switch my water pressure gauges
to water temp gauges.
These gauges are for 1991 twins - 200TXRP & 200TLRP.
The water pressure gauges have just 2 wires (black & blue).
The water temp gauges have the black & blue, but also
have 2 black, 1 yellow and 1 light blue.
Where do these 4 go? And how can I make them go if there are
no such wires on the pressure gauges?
Also, Is there an extension wire harness for the connection between
the ignition harness (# 6K1-82570-02-00) and the main harness?
My wires just reach and are tight, I would like to add some slack.
to water temp gauges.
These gauges are for 1991 twins - 200TXRP & 200TLRP.
The water pressure gauges have just 2 wires (black & blue).
The water temp gauges have the black & blue, but also
have 2 black, 1 yellow and 1 light blue.
Where do these 4 go? And how can I make them go if there are
no such wires on the pressure gauges?
Also, Is there an extension wire harness for the connection between
the ignition harness (# 6K1-82570-02-00) and the main harness?
My wires just reach and are tight, I would like to add some slack.