I had my carbs rebuild but the guy who did it stiffed me. Now i have carb issues.
1> The engine will start but won't stay started. I know its the air flow but not sure where the screws should be set to. How can I reset them to factory settings.
2> the outboard runs but only go's about 5 mph and won't go faster then that. He was messing with the air adj screws on both carbs and this is what happened. Nothing else was messed with after he did this, the eng ran fine before this. Anyone any ideals?
Thank you Kc
1> The engine will start but won't stay started. I know its the air flow but not sure where the screws should be set to. How can I reset them to factory settings.
2> the outboard runs but only go's about 5 mph and won't go faster then that. He was messing with the air adj screws on both carbs and this is what happened. Nothing else was messed with after he did this, the eng ran fine before this. Anyone any ideals?
Thank you Kc
Comment