Buy Yamaha Outboard Parts

Announcement

Collapse
No announcement yet.

Remote switch at motor for Trim and tilt.

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Remote switch at motor for Trim and tilt.

    Can someone tell me where I can go to purchase a switch and how to install at motor for my 1998 C150 motor trim and tilt? It is a hassle to climb into boat just to activate the swtitch at the control box.

  • #2
    You would have to install a toggle switch(waterproof) on bottom engine cowling or in boat and splice into the smaller green(trim down), blue(trim up) and red(battery voltage) wires at trim relays.
    Regards
    Boats.net
    Yamaha Outboard Parts

    Comment


    • #3
      tilt switch install

      I also, have a similar year model, without the on motor switch.

      You may have the original owners and service manuals. A great amount of information.
      I ordered a the generic manual , however very limited.

      Sent me a Private message on this site. Maybe my phone( faster solving troubles)

      Sure I can help ..

      Comment


      • #4
        I bought a water tight "transom switch" from West Marine that cost about $25. As written above, red = 12v, blue= up, green= down. It's not a "replacement" to the OEM switch that's on the motor but can be installed at the transom where it can easily be reached either from outside or inside the boat.

        Comment

        Working...
        X