Buy Yamaha Outboard Parts

Announcement

Collapse
No announcement yet.

Hot hand wash water

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Hot hand wash water

    I've got a T8, only a couple of years old that quit putting out warm water for hand wash station. Nothing coming out. Tube goes to fitting on engine with a little fitting. Impossible to get a socket or end wrench on it.

    Anyone with experience in making the warm hand wash work again??

  • #2
    Normally you can use a plastic staw off of WD-40 can to clean nipple out at cowling. May have to blow it out with compressed air.
    Regards
    Boats.net
    Yamaha Outboard Parts

    Comment


    • #3
      Thanks, I tried poking it with a piece of wire and it seemed clear, but I'll try the compressed air idea too. Removing the whole fitting seems challenging since its got the nipple attached and a socket won't fit and there's not much room for end wrenches.

      I hope the air does it.

      Comment

      Working...
      X